TT2742 RSgen2 Spec ESC 17.5rpm

  • Pinterest
This is the Tekin RS5 Gen 3 Brushless Sensored 17.5T RPM Motor and the RS Gen2 SPEC Brushless Electronic Speed Control. FEATURES: TT2704 RPM Motor (TEKC2704); RPM version designed for applications where higher RPM is more benefical than torque Ideal for 1/12 and touring car racing classes CNC machined T 6061 billet aluminum heat sink can For on- or off-road use 12.5mm performance rotor Dual-plug sensor wire harness for all sensored and sensorless systems Anodized end-bell plates maximize corrosion and wear resistance High RPM precision ball bearings Neodymium sintered magnet Rebuildable Adjustable timing Low resistance solder tabs Solderless sensor PCB replacement ESC (TEKC1155); Compatible with sensored, sensorless, brushless, and brushed motors Datalogging capability True ROAR spec mode only, no timing or boost features available High voltage programmable Battery Eliminator Circuit (BEC) HotWire PC interface for advanced programming and updating, EZ access programming port (HotWire Interface (TEKM1450), and Gen 2 Adaptor (TEKM3825) required) Forward, brake, and reverse operation D2 Dual Drive Mode technology On-board temperature indicator Sensor plug for precise commutation with all motors Gold plated solder posts Pit tune mode HDAC: High Density Copper PCB's Self test diagnostics and factory reset DGF2 Digital Glitch Filtering V2 QuickTune programming with one-touch radio calibration 120 day limited warranty through Tekin beginning at date of purchase INCLUDES: RS Gen 2 Spec D2 Brushless ESC with Instructions, Motor and Receiver Wires Redline GEN3 17.5 Turn RPM Brushless Sensored Motor with Sensor Wire SPECS: ESC; Input Voltage: 4-7 cells NiMH/NiCd, 2S LiPo BEC: 6.0V / 3.7V Amperage: 60A per phase Motor Limit Brushless Mode 2S: 13.5T 2-Pole 36mm Can Motor Limit Brushed Mode 2S: 20 Turn 36mm Can Max Chassis Weight: 4lbs (1815g) Throttle Profiles: 7 choices on-board Brushed Modes: Fwd Only, Fwd/Rev, Rev Delay Brushless Modes: Fwd Only, Fwd/Rev, Rev Delay Dimensions: 1.0 x 1.3 x .51" (26 x 34 x 12.9mm) Weight: .80oz (22.5g) 17.5T RPM Motor; Input Voltage: 2S all, 3S-10.5 and up Shaft Dimensions: 3.2mm (1/8") x 15.3mm Weight: 5.6oz (158g) Motor Diameter: 1.40" (35.85mm) Motor Length: 1.9" (48.5mm) Bearing Dimensions: Front: 4x13x5mm / Rear: 1/8x3/8x5/32" Rotor Size: 12.5mm